实时新闻资讯·带您了解各种类型的水上乐园

服务热线电话

400-840-8766

水上游乐设备本身容易出现的八个问题

来源:https://www.hcseaworld.com/ 日期:2022-06-28 发布人:admin 浏览量:

游乐设备的经营者经常被各种游乐设备的故障所困扰。游乐设备再好或保养得再好,总会有一些问题。因此,我们必须找到解决问题的技巧和方法。下面就来说说水上游乐设备本身容易出现的八个问题。
The operators of amusement equipment are often troubled by the faults of various amusement equipment. No matter how good the amusement equipment is or how well it is maintained, there will always be some problems. Therefore, we must find the skills and methods to solve the problem. Here are eight problems that are easy to occur in water amusement equipment.
1、链条抖动。
1. Chain shakes.
可能的原因是链条太松,负载太高或一个或多个链节不灵活。解决方案是安装链条张紧器或可调节的芯距。尽可能减少负载。
The possible causes are that the chain is too loose, the load is too high, or one or more chain links are not flexible. The solution is to install a chain tensioner or an adjustable core distance. Reduce the load as much as possible.
2、链板疲劳。
2. Chain plate fatigue.
当载荷过大,超过链板的疲劳极限时,链板会发生疲劳破坏,在孔周围产生微裂纹,直至断裂。解决方法是减轻负载或更换承载能力大的链条。
When the load is too large and exceeds the fatigue limit of the chain plate, the chain plate will be fatigue damaged, and microcracks will occur around the hole until it breaks. The solution is to reduce the load or replace the chain with large bearing capacity.
3、链轮齿磨损。
3. The sprocket teeth are worn.
如果链轮齿两侧有明显磨损,说明传动对中不好。如果有“弯槽”,则说明磨损过大,应更换链轮,或将链轮倒转,使磨损较小的一面朝向链条。过度磨损的链轮用链条代替。
If there is obvious wear on both sides of the sprocket, it indicates that the transmission is not well aligned. If there is a "bend groove", it means that the wear is too large. Replace the sprocket, or turn the sprocket upside down so that the less worn side faces the chain. Excessively worn sprockets are replaced by chains.
4、销子磨损。
4. The pin is worn.
销磨损的原因可能是润滑不足。经常检查油中是否有磨料或改变润滑方法。
The cause of pin wear may be insufficient lubrication. Frequently check whether there is abrasive in the oil or change the lubrication method.
水上游乐设备厂家
5、链条和链轮不合适。
5. Improper chain and sprocket.
如果链条和链轮未正确组装,则链条的铰链可能会磨损并且节距变长。如有跳齿现象,应及时更换链条。如果链轮磨损,请更换它,以免损坏新链条。
If the chain and sprockets are not assembled correctly, the hinges of the chain may be worn and the pitch may become longer. In case of tooth skipping, replace the chain in time. If the sprocket is worn, replace it to avoid damaging the new chain.
6、链板侧面磨光。
6. The side of chain plate shall be polished.
如果内链板的内表面磨损严重,则传动失准。解决方法是检查轴和链轮的对齐情况。如果安装没有问题,可以观察在运行过程中是否因负荷过大和变形而导致刚度不足。
If the inner surface of the inner chain plate is severely worn, the transmission is out of alignment. The solution is to check the alignment of the shaft and sprocket. If there is no problem in installation, it can be observed whether the stiffness is insufficient due to excessive load and deformation during operation.
7、引脚接合。
7. Pin engagement.
粘针通常是由于供油不足造成的。如果只有一端卡住,检查轴和链轮的安装,轴是否平行,链轮是否共面,运行时轴和链轮是否移动。
Sticking the needle is usually caused by insufficient oil supply. If only one end is stuck, check the installation of the shaft and sprocket, whether the shaft is parallel, whether the sprocket is coplanar, and whether the shaft and sprocket move during operation.
8、链条张力异常。
8. Abnormal chain tension.
水上游乐设备厂家认为链条的张力与链条松边的下垂距离有关。对于具有可调节芯距的平移和倾斜驱动器,链条松动边缘的下垂度应约为芯距的2%。如果芯线被垂直驱动或承受振动载荷,反向驱动应使链条更紧。
The manufacturer of water amusement equipment thinks that the tension of the chain is related to the sag distance of the loose edge of the chain. For translation and tilting drives with adjustable core distance, the sag of the loose edge of the chain shall be approximately 2% of the core distance. If the core wire is driven vertically or under vibration load, the reverse drive shall make the chain tighter.
以上就是问题解答的相关内容了,希望能够帮助到大家,如对这一问题还存在任何疑问,都欢迎关注我们网站https://www.hcseaworld.com并咨询我们的工作人员,将竭诚为您服务。
The above is the relevant content of the question answer. I hope it can help you. If you still have any questions about this problem, you are welcome to follow our website https://www.hcseaworld.com And consult our staff, will serve you wholeheartedly.

需要一些帮助选择吗?

我们有一个行业专家团队,他们很乐意与您讨论您的项目及其需求,
以帮助您找到合适的人选。
让我们开始吧 咨询电话:15662636467

网站导航

服务热线

400-840-8766

汇川·致力于创新与普及软体水上乐园

  • 【安经理】

  • 【张经理】

  • 【技术咨询】

  • 【售后服务】

济南汇川环保科技有限公司 地址:山东省济南市槐荫区财富壹号广场

技术支持:网站建设·推广运营备案:鲁ICP备20031739号-3

在线留言

聚力汇川·达成共识信任汇川合作共赢
  • 您的姓名:
    您的电话:
    您的地址:
  • 选择项目:
  • 您的需求:
  •  

截屏,微信识别二维码

微信号:hc19861811151